One-piece flexible TPU wraparound grip for SIG Sauer P226, P226 DAK and P226 MK25 (classic DA/SA frame). Both sides and the backstrap in one part. Twists and springs back, does not crack or chip. Coarse non-slip texture on the whole surface, no finger grooves. Black. 107.0 mm tall, 34.0 mm wide, 4.4 mm side walls, screw holes 65.2 mm apart. Reuse your original screws (not included). Does not fit SAO, Legion, X-Series, P220, P229. Grip only, no pistol.
Zib Grips
One grip. All the way around.
A one-piece flexible TPU grip for the SIG Sauer® P226. Both sides and the backstrap in a single part, with a coarse non-slip texture everywhere your hand lands.
Bends. Twists. Springs back.
Printed in TPU, a rubber-like elastomer. Twist it a full 90 degrees in your hand and it returns to shape. No cracks, no chips, no splinters.
Flexible enough to squeeze.
The side walls give under pressure and recover instantly, so the grip settles into your hand instead of fighting it.
Grip that stays put.
The whole outer surface carries a coarse, irregular texture with no smooth border and no slick spots. Firm hold, wet or dry.
Why this grip
No finger grooves
A smooth front profile fits any hand size; your fingers go where they want.
Texture edge to edge
Coarse non-slip texture on both sides and the backstrap.
Slim walls
4.4 mm side walls, 34.0 mm overall width.
One piece
Wraps the backstrap. Nothing to lose, nothing to rattle.
Fits
✓SIG Sauer P226 — classic DA/SA frame with two-piece factory grips
✓SIG Sauer P226 DAK
✓SIG Sauer P226 MK25
Does not fit
✕P226 E2
✕P226 SAO
✕P226 Legion
✕P226 X-Five / X-Series (X5, X6)
✕SIG P220, P229, P320, P365
TacOps or Elite? Not confirmed yet — send us a photo of the left side of your pistol and we will check before you order.
Specifications
Material
TPU (thermoplastic polyurethane), flexible, 3D printed
Screw holes
Ø 6.2 mm, 65.2 mm apart (±0.5 mm)
In the box
1 one-piece grip
Screws
Not included — reuse your original grip screws
Fitting in four steps
1Unload the pistol, remove the magazine and check the chamber is empty.
2Remove the grip screws and the factory grip panels.
3Open the grip slightly and fit it around the frame so it wraps the backstrap; line up the screw holes.
4Refit your original screws and tighten snugly.
Questions
Is it rubber?
It is TPU, a thermoplastic elastomer with a rubber-like feel that is firm enough to hold its shape on the gun.
Are screws included?
No. Your original P226 grip screws are reused.
Will it fit my P226?
Classic DA/SA, DAK and MK25 frames with two-piece factory grips. Not SAO, Legion or X-Series. Unsure? Send us a photo.
Does it come with a pistol?
No. This is the grip only. Not for airsoft or replica pistols.
Zib Grips is an independent aftermarket maker. SIG Sauer® and P226 are trademarks of their owners and are used only to describe fit. Not affiliated with or endorsed by the firearm manufacturer.
